Test voltage 100 – 5 000 V AC,
Test current, limit 0,5 - 100 mA
Power > 500 VA
Short circuit current > 200 mA, EN 61180
Potential free suitable for testing with test pistols, according to EN 50191
- Over limit trip and over current detection
- Digital interface for remote control by PLC (Start, Stopp, In Operation, Failed)
- Signalling: Acoustic, optical and via digital interface
- Safety circuit
Shut-down over limit detection and over current detection Insulation fault alarm will be triggered by a current over limit exceedance or by a over current detection in order to detect even low-energy spikes.
Test device for operating “Stand-Alone” or remotely controlled via interface
The test device can be digitally controlled by a PLC (Digital-IO).
Activating the test voltage
The test voltage can be activated by push buttons on the device front, or over the control interface on the back side.
Signalling: Acoustic, optical and communication interface
Faulty test objects can be reliably identified. Indication lights will also flash additionally.
Measuring of current and voltage directly on the high voltage section
Direct measurement guarantees accurate test results.
High voltage, potential-free
The test voltage is potential-free. This grants highest possible security for the operating person and is a requirement for performing high voltage tests by using test pistols.
Control interface / Digital-IO
Digital interface for connection to a PLC or a footswitch.
Safety circuit
For standardized testing with test pistols.
Signal light connector
For connecting a signal light combination consisting of red and green allround lights.
